Technology and engineering · 2016

RFC 7820: UDP Checksum Complement in the One-Way Active Measurement Protocol (OWAMP) and Two-Way Active Measurement Protocol (TWAMP)

by T. Mizrahi

The One-Way Active Measurement Protocol (OWAMP) and the Two-Way Active Measurement Protocol (TWAMP) are used for performance monitoring in IP networks. Delay measurement is performed in these protocols by using timestamped test packets. Some implementations use hardware-based timestamping engines that integrate the accurate transmission time into every outgoing OWAMP/TWAMP test packet during transmission. Since these packets are transported over UDP, the UDP Checksum field is then updated to reflect this modification. This document proposes to use the last 2 octets of every test packet as a Checksum Complement, allowing timestamping engines to reflect the checksum modification in the last 2 octets rather than in the UDP Checksum field. The behavior defined in this document is completely interoperable with existing OWAMP/TWAMP implementations.

Anyone can see what's on the shelves. Open a book with a free account, and stay in touch with its book club.

First published
2016
Status
Experimental
Pages
15
Copyright
✓ Free to read · Copied in full, as published

Where it comes from

RFC Editor · IETF Datatracker · IETF Trust Legal Provisions

Copied in full and unchanged from the RFC Editor, with the RFC's own notices. © IETF Trust and the persons identified as the document authors. The IETF Trust allows copying and distributing an RFC in full and without modification, so Micwyn shows it exactly as published and makes no study guide, audio or other version of it.

Discuss a passage

Select any passage in the reader and press Discuss to talk about it in public.

Join free to discuss a passage

Ask Micwyn about this book

Join (free) to ask about a PDF
Try asking

If you like this one